H3C 链路聚合

发布时间：2019-09-15 09:56:49编辑：auto阅读（2654）

    二层聚合：

    一、静态聚合

    [SW]int Bridge-Aggregation 1 

    [SW-Ethernet1/0/1]port link-aggregation group 1

    [SW-Ethernet1/0/2]port link-aggregation group 1

    [SW-Bridge-Aggregation1]port link-type trunk

    [SW-Bridge-Aggregation1]port  trunk permit vlan all 必须先加入端口再起Trunk，要不然会出错

    二、动态聚合

    [SW]int Bridge-Aggaregation 1 

    [SW-Bridge-Aggregation1]link-aggregation mode dynamic 

    [SW-Ethernet1/0/1]port link-aggregation group 1

    [SW-Ethernet1/0/2]port link-aggregation group 1

    [SW-Bridge-Aggregation1]port link-type trunk

    [SW-Bridge-Aggregation1]port trunk permit vlan all

    查看命令：

    display link-aggregation summary

    [S1]display link-aggregation verbose


    负载分担：

    [S1]link-aggregation load-sharing mode destination-mac  两端都配置（貌似接口也可以配置）


    三层聚合：

    [R2]int Route-Aggregation 1

    [R2-Route-Aggregation1]ip add 12.1.1.2 24

    [R2]int g0/0

    [R2-GigabitEthernet0/0]port link-aggregation group 1

    [R2-GigabitEthernet0/0]int g0/1

    [R2-GigabitEthernet0/1]port link-aggregation group 1


    负载分担：

    [R1]link-aggregation global load-sharing mode source-ip destination-ip基于源IP，目的IP


关键字：

上一篇： Python（二）python简介

下一篇： python 计算时间差